1. Check if the window frame is level before mounting the brackets.Measure the shade's headrail with a tape measure.Mark the bracket locations on the frame with a pencil.Mark the screw locations for each bracket with an "X".

2.Drill pilot holes into the “ceiling” of the window frame.Screw the brackets into the pilot holes with a screwdriver.

3.Slide the shades into place in the mounted brackets.Drive a head screw into each end bracket to secure the shade.

1. Sort out and prepare mounting brackets.Align brackets with a level tool and mark their positions.

2.Mark screw locations and drill pilot holes.Screw brackets in place.Slide or snap headrails into the brackets.

3.Test operation of your outside mount Roman shades.Install a valance to conceal hardware and enhance decor.

1. Place the first bracket in the upper corner of the window frame, flush with the wall. Mark screw locations and repeat on the other side, ensuring both brackets are even.

2.Drill pilot holes at the marked locations.Drill screws into the pilot holes to secure the brackets.

3.Slide the headrail into the brackets and secure them. Hook the wand to the top clip. Attach the valance tips if included. Lower and test the blinds for proper installation.

1. Mark the blinds' left and right edges on the wall.Align brackets with markings and drill pilot holes.

2.Screw brackets into place. Add a center support bracket if needed.Snap valance clips onto the headrail, avoiding interior parts.

3.Slide headrail onto brackets and close covers.Use L brackets for side returns, then snap valance into clips.Lower and test blinds for proper function.

1. Measure in from each top corner of the window frame according to the manufacturer's specifications. Mark the bracket positions.

2.Position the brackets above your markings and drill pilot holes where the screws will go.Screw the brackets into place.

3.Raise the shade into the frame and position the headrail into the brackets. Rotate the headrail down until it snaps into place.Lower and test your new shade to ensure proper installation.

1.Position the shade on the wall and mark the bracket installation points along the top of the headrail with a pencil. Place the brackets along the marks, drill pilot holes, and secure them with screws.

2.Align the headrail with the brackets and push up to secure it, ensuring the threaded posts fit through the slots.

3. Lift the valance, secure the shade with wing nuts, and cover the ends of the headrail with side flats. Lower and test the shade for proper installation.